Stainless Steel Milk Cooling and Storage Tank

Product Description

Description:  

 

The Sanitary grade Stainless steel 304 milk cooling tankis mainly used in cooling to storage milk or other liquid. It absorbs international advanced technology, adopts importing compress machine, safety and protection system, micro computer monitor, advanced technique and equipment such as polyurethane bubbling, honeycomb board evaporator. So it is the ideal cooling and storage equipment for pasture, milk station, milk factory, food factory, and beverage factory and pharmacy industry for keeping the milk raw milk in its best situation and prevents the bacteria. 

 

This system can cooling large area of the inside pot surface, utilizing the automatic computer control system to observe and operate, which can quickly lower the temperature to 4and keep to this constant temperature, that prevent from the growth of the bacteria.

 

The refrigeration compressor unit are choose the excellent performance and energy-saving European Maneuropcompressor, equipped with the creditable midpoint protector that will prevent the equipment from burning out caused by over loading or system fault. The heat preservation layer utilized the new technique of the anti-aging polyurethane blister; it owns the brilliant characteristics of heat in solutions. The body of the Pot(vessel) make by the high quality stainless steel material 304 (OCr18Ni9), equipped with automatic cleaning ball and mixing system.

 

Capacity	Refrigerant Unit	Compressor	Mixing speed	Refrigerant	Tank Body Size (LWH)
500L	SANYO     COPLAND	2.5P	36RPM	R-404a/R-22	/
1000L		3P			1680*1210*1300mm
2000L		5P			2050*1500*1500mm
3000L		6P			2380*1700*1600mm
4000L		8P			2630*1800*1700mm
5000L		10P			2980*1900*1800mm
6000L		12P			3080*2100*1950mm
7000L		12P			3300*2100*1950mm

Requirements before installation:
Must be careful when you carry it, do not tilt more than 30°to any position.
Check the wooden case, make sure it is not damaged.
The refrigerating fluid has already been filled into the unit, so it is not allowed to open the valve of the compressor unit during transportation and and storage.

Location of work house:
The work house should be spacious and good air liquidity. There should be an one-meter passageway for operator working and maintain. When it is mechanized milking, you should consider about the connection with other equipment.
The foundation of the tank should be 30-50 mm higher than the floor.

Installation of the tank:
After the tank got in position, please adjust the feet-bolts, make sure the tank tilt to the discharge hole, but not too much, just can discharge all the milk in the tank. You must make sure the six feet uniform stress, do not allow any foot be drift. You can adjust the left-right slope by Horizontal scale, make sure it is not slope to left or right.
Switch on the inlet of condenser.
The equipment switch on electric power must switch on the earth.

Product pictures: